6 | minnkotamotors.com
©2016 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE ULTERRA
• #2 Phillips Screwdriver
• #3 Phillips Screwdriver
• Drill
• 9/32" Drill Bit
• A person to help with
installation
MOUNTING CONSIDERATIONS
TOOLS AND RESOURCES REQUIRED
INSTALLATION
a. Place the mount on an elevated, level surface
such as a workbench or the tailgate of a pickup.
The motor, as removed from the box, should be in
the stowed position.
b. Remove the four sideplate screws using a #3 or
#2 Phillips screwdriver. Two of these screws will
be located on each side of the mount.
It is recommended that the motor be mounted as close to the keel or centerline of
the boat as possible. Make sure the area under the mounting location is clear to drill
holes and install nuts and washers. Make sure the motor rest is positioned far enough
beyond the edge of the boat. The motor must not encounter any obstructions as it is
lowered into the water or raised into the boat when stowed and deployed. Consider
a quick release or adapter bracket with the installation of your motor. To view a list of
accessories, please visit minnkotamotors.com.
c. Remove the Right Sideplate to access the
Mounting Slots.
d. Remove the Left Sideplate to access the
Mounting Holes.
1
2
View accessories
available for your
trolling motor at
minnkotamotors.
com.
NOTE: This motor weighs approximately 70 lbs.
We recommend having a second person help with
the installation.
Deployed
Stowed
2d
Left Sideplate
Right
Sideplate
2c
Right
Sideplate
1b
Screw
Screw
1b
Left Sideplate
Screw
Screw
Installing the Ulterra
To Next Page
Loading...
Need help?
General
