7
Explanation of each command
In" " of the format of the control side (personal computer side) Ë this
product (CS-100A), 0 - 9, and ".(period)", " (space)" comes in.
The number of " " means the number of input letters.
In case to input fewer number of letters than the specified number of
letters, input space as many times as the shortage letters and them input
the numeric value.
[Example]In case to input "12.4" into the format of " ", input
" ¢¢ 12.4" (¢ is a space.).
In" " of the format of this product side (CS-100A) Ë the control side
(personal computer), 0 - 9, and ".(period)", " (space)" comes in.
The number of " " means the number of letters. Therefore, in case to
output the numeric value of "12.4" to the format of " ", the
letter string of " ¢¢ 12.4" (¢ is a space.) is outputted.
In the notation, specifying delimiter is omitted.
The following errors that are possible to occur at any time are not clearly
specified in the explanation. When these errors occur, only the check
command corresponding to each error is outputted in case of the output from
[this product Ë control side] in the explanation.
@¨ "ER00" cccc Command error
A command other than the above-mentioned command is
inputted. Out of the parameter setting range
@¨ "ER11" cccc Memory value error (same as E1 display)
@¨ "ER20" cccc EEPROM error
The value in the protect area of EEPROM is broken,
cannot access EEPROM, etc.
@¨ "ER30" cccc Battery out
Same as B0 display. The power voltage is lower than
the BC voltage.
To Next Page
Loading...
Need help?
General
