9
Command MDS
Function Carries out various mode settings
Control side Ë this product format
"MDS, "
This product Ë control side format
Only error check command
Control sideËthis product format details
In the 2-digit parameter following the command code, the following
numeric value comes in according to the measuring mode to set.
MINOLTA calibration standard mode
"00"
Same as the calibration switch [PRESET] side.
@Arbitrary calibration standard mode "01"
Same as the calibration switch [VARI] side.
@Color measuring mode "04"
Same as the measuring mode switch [ABS] side.
@Color difference measuring mode "05"
Same as the measuring mode switch [DIFF].
@Measuring response time 100 msec. "06"
Same as the response switch [FAST] side.
@Measuring response time 400 msec. "07"
Same as the response switch [SLOW] side.
This productËcontrol side format details
Only error check command
Command RCR
Function @Recalculates according to the mode setting and outputs the
calculated result from the RS terminal.
@The measured value is held, or held by this product.
Depending on the condition of the measured value, an error
may occur.
When luminance and chromaticity setting range over
(same as E0 display)
When chromaticity measuring range over
(same as E0 display)
When luminance display range over (same as E9 display)
In case that the measured value is not held
(same as E display)
Control side Ë this product format
"RCR"
To the Next page
To Next Page
Loading...
Need help?
General
