98
Cust 4 — DX Memory
1 – DX Memory Off
Film speed is always set to the DX-coded ISO. Non-DX-coded film is set to the
previous roll’s ISO.
2 – DX Memory On
Changes to the film speed for a DX coded roll are saved and applied to future rolls
with the same DX coded ISO. Use to consistently over/under-expose a specific film
type.
•Film must be loaded before the ISOcan be changed.
Cust 5 — Release Lock (Film)
1 – Release Lock Off
2 – Release Lock On
Shutter cannot be released unless film is loaded or the back cover is open.
•blinks in the frame counter if the shutter-release button is pressed when film is not
loaded.
Mid Reload
Mid Reload decreases the chances of accidental double exposure when reloading a
partially exposed roll of film.
•Reloading a partially exposed roll increases the risk of film damage (scratches) caused by
dust and grit.
1. Set custom function 3 to setting 3 .
2. Load the film.
•The film is automatically advanced to frame 1.
3. Open the control panel door, then
press and hold the adjust button
until 1 blinks in the data panel.
4. Turn either control dial until the
frame number you want to advance
the film to blinks in the data panel.
•Advance the film a minimum of two frames past
the last exposed frame.
5. Press the adjust button.
•The film is automatically advanced to the desired
frame.
English
CUSTOM FUNCTIONS
To Next Page
Loading...
Need help?
General
