Minolta MN200NV - Camcorder Power and Mode Switching; Connecting to External Devices

2. First Use

2.4 Powering the Camcorder On/Off
Hold the POWER button for 3 seconds to power the camcorder on. To
power the camcorder off, press and hold the POWER button for a further 3
seconds.
The camcorder will automatically power on and off when the screen is
opened or closed. If the camcorder’s battery is low, a “Low Power”
message will display on the screen and it will automatically shut down
within a few seconds to prevent memory corruption or loss.
2.5 Switching Modes
Press the MODE button to cycle between Video, Photo, Playback and
Setup Modes. The corresponding mode will be displayed in the top left
corner of the screen.
2.6 Connecting to a Computer
Your camcorder can connect to a computer to transfer photo and video
files for viewing and editing, as shown below. Once connected and
powered on, the camcorder’s screen will enter “Mass Storage” mode
automatically.
1. Connect the small end of the
USB cable to the USB port
on
the camcorder.
2. Connect the large end of the
USB cable to the USB port
on
the computer.