Minolta MN60WP - Photo Burst

25
2.3 Photo Burst
In photo burst mode, the camera will take a set number of images with each
press of the SHUTTER button.
To enter Photo Burst mode, power the camera on and press the MODE
button to access the mode selection screen and use the UP or DOWN
buttons to select Burst and press the OK button to enter that mode.
1.
Line up your shot by looking at the LCD screen to see what is in the shot.
2.
Hold the camera steady and press the SHUTTER button to capture a
photo.
3.
The number of photos that can be captured at a particular resolution will be
displayed in the top of the screen.
4.
The number of pictures remaining will be 0 if there is no memory card
i
be shown at the screen when the memory card is full.
5.
The number of remaining photos is determined by the selected photo
resolution. The higher the photo resolution, the lower the number of photos
you are able to be save to the memory card. Before capturing any photos,
you can select a preferred photo resolution.
The front LCD screen can be used to take selfies. Simply press the SWITCH
SCREEN button and the front LCD screen will turn on. Then use the camera
as normal. Press the SWITCH SCREEN button to turn the rear LCD screen
back on.
Note: Only one LCD screen is active at a time, when one of the screens is
off, this is not a malfunction.
2.3.1 Photo Size
This function sets the photo resolution. The higher the resolution, the greater
the photo quality and the larger the file size of the photo.
1. In Photo Burst Mode press the MENU button.
2. Press the OK button to enter the Photo mode settings.
3. Select Photo Size using the UP or DOWN buttons.
4. Press the OK button to enter the Photo Size submenu.