Minolta MN60WP - Page 49

48
2.8.2 Interval Duration
This function allows you to set the amount of time in between images.
1. In Time Lapse Mode press the MENU button.
2. Press the OK button to enter the Photo mode settings.
3. Select Interval Duration using the UP or DOWN buttons.
4. Press the OK button to enter the Interval Duration submenu.
5. Press the UP or DOWN buttons to navigate the menu, and press the OK
button to confirm your selected resolution (0.5 Seconds, 1 Second, 2
Seconds, 5 Seconds, 10 Seconds, 30 Seconds, 60 Seconds).
6. Press the MENU button twice to exit the settings menu.
single
frame every 10 seconds and create a video combining all of the
captured images. See the table below for how long it will take to record
1 second of video for each option;
Interval Duration Option
Length of time to record 1
second of video
0.5
Seconds
15 Seconds
1 Second
30 Seconds
2 Seconds
60 Seconds
5 Seconds
150 Seconds
10 Seconds 300 Seconds
30 Seconds
900 Seconds
60 Seconds 1,800 Seconds
2.8.3 Distortion Correction
This function enables the camera to correct slight image distortions by
straightening the image and enhances it to appear more natural.
1. In Time Lapse Mode press the MENU button.
2. Press the OK button to enter the Photo mode settings.
3. Select using the UP or DOWN buttons.
4. Press the OK button to turn Distortion Correction on and off, a check mark
indicates that the feature is active.
5. Press the MENU button twice to exit the settings menu.
Note: Distortion Correction is only available when the Movie Size setting
is 1080P or 720P.