Minolta X-370N - Safe Load Signal and Frame Counter

LOADING FILM
Before opening the camera back,
make sure there is no film inside
the camera
by checking the film
window (p. 12) .
NOTE
• When loading film in a dark place
or wi th the lens cap on, loading
will be easier if the mode selector is
not set at "AUTO" .
1.
Unfold the rewind crank and
pull up on it to lift the back-cover
release
knob. Pull up on the knob
until the camera back springs open .
2. Leaving
the knob pulled out,
position a 35mm film cartridge in
the chamber with its p ~ ojecting
spool down . Then push the back-
cover release
knob all the way in,
rotating it slightly if necessary .
•
Always handle and load f i lm in subdued light or at least shaded
from direct light by your body.
• Do "0' ,o.'h '"V""' ""M' ~ l
inside the camera shown in blue . ~ _ .
13