1. With the case off, pull up on the
back-cover release knob until the
camera back springs open. Gently
blow away any dust or other parti-
cles inside with a blower brush.
NOTE
• When loading film in a dark place
or with the lens cap on, loading will
be easier if the mode selector is not
set at "P" or "A".
18
2. Leaving the knob pulled out,
position a 35mm film cartridge as
shown with the projecting spool
down. Then push the knob all the
way in, rotating it slightly if neces-
sary.
NOTE
• If the film-advance lever stops at
the end of a full stroke during the
following steps, release the shutter
and continue (main switch must be
on).
3. Pull out enough film leader to
just reach the take-up spool, then
insert the end into a slot on the left
(as shown above), making sure it
does not protrude from another
slot. A hole in the film should be
lined up with the tooth on the
take-up spool, and the sprocket
teeth should be engaged with holes
at the bottom of the film.
To Next Page
Loading...
