Minolta XG-A - Film Speed Setting; Setting Film Speed

18
5. After making sure the film is taut, close the
camera back and push in on it until it clicks
locked.
6. A red "S" should now appear opposite the
index in the frame-counter window. Ad-
vance film and release the shutter until the
index points to "1" on the frame-counter
dial.
7. A red bar should also now appear at the
extreme left in the Safe Load Signal
window. This indicates that the film is
loaded and winding properly on the take-up
spool. If the Safe Load Signal does not
appear or swings far to the right in the
window, repeat steps 1 through 6 to assure
that fi 1m is properly engaged on the spool.
As
you continue to take pictures, the red
signal will move gradually toward the right
in the window, indicating that film is
advancing properly.