Minolta XG-A - Page 53

Flash sync: Hot shoe for X sync (disconnects when unit not installed): Electronic flash
synchronizes at 1/60 sec.
Extra contact on hot shoe receives signal from camera-control contact of
th,e X-series Auto Electroflashes
Film advance : Motorized : Through built-in coupler key with accessory Auto Winder G
Manual:
By lever with single 130
0
stroke after 30
0
unengaged movement
Film-advance release button for rewindi ng ; advancing- type frame counte r
and Safe Load Signal
that indicates film loading and advancing conditions
Power: Two 1.5v alkaline-manganese (Eveready A-76 or equivalent) or 1.55v
silver-
oxide (Eveready EPX-76/S-76 or equivalent) cells conta ined in
camera
base power both auto exposure control and shutter's electronically
governed operation .
LED battery check -i ndicator lights when operating switch in battery check
position
Shutter will not release when voltage too low for proper operation
Self- timer : Electronic , LED indicated types; approx i mately 10 sec. delay
Other: 4-slot take-up spool.
Si
ze and weight: 52 x 88 x 138mm (2 x 3-7/16 x 5-5/8 in.)
485g (17-
1/8 oz .) without lens and power ce l ls
Accessori es : Exclusive Auto Winder G, Auto Electroflash 320X , 200X , 132X and 118X ,
Wireless Controller IA - 1, Aemote Cord S 50cm (20-in.) and Aemote Cord
L 5m (16-ft .); MD , MC and other interchangeable Minolta lenses and
applicable
Minolta SLA system accessories
Speci
fications subject to change without notice
51