MINOURA VFS150 - User Manual

Indoor Bicycle Trainer instructions manual
Minoura Japan Headquarters Minoura North American Tech Center
(for all customers) (for U.S. residents only)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan 1996 East Avenue, Hayward, CA 94541 U.S.A.
Phone: +81-584-27-3131 / Fax: +81-584-27-7505 Phone: 1-510-538-8599 / Fax: 1-510-538-5899
Email: minoura@minoura.jp Email: support@minourausa.com
www.minoura.jp
Made in Japan
VFS150
Read this instructions carefully before use
(Image: VFS150 non-remote type)

Summary

Important Notice

VFS150 Schematics

How To Setup Your VFS150 Trainer

Replace Rear Wheel Skewer

Ensure stability by using the supplied quick release skewer for the rear wheel.

Install VFS Unit to Base Plate

Mount the VFS unit onto the Base Plate and tighten bolts with an M5 hex wrench.

Position Trainer on Floor

Place the VFS150 on a level floor, ensuring all four feet make contact for stability.

Place Rear Wheel in Couplings

Insert the bike's rear wheel between the left and right side couplings securely.

Contact Drive Roller to Tire

Adjust the drive roller to contact the rear tire, achieving 3-4mm compression for optimal performance.

How To Adjust Resistance Level

Mount Remote Shifter Band

Wind the band around the handlebar and hook the metal ring to the shifter base.

Lock Shifter Lever

Flip up the lever to lock the remote shifter; adjust band tightness if loosened.

Adjust Band for Handlebar

Adjust the soft fabric band for normal 22mm handlebars or special shapes.

Operate Resistance Lever

Twist the lever towards 'H' to increase or 'L' to decrease resistance, offering 7 levels.

Troubleshooting Remote Shifter

Adjust Initial Cable Tension

Fix shifting problems by adjusting the cable tension via the adjusting screw and lock nut.

How To Use Small Wheel Adaptor

MINOURA VFS150 Specifications

General

Type	Upright
Model	VFS150
Brand	Minoura
Resistance	Magnetic
Pedal Type	Standard
Braking System	Magnetic