How to fix Minuteman Endeavor RTXL UPS error code E19 bad battery?
If your Minuteman UPS shows error code E19 indicating a bad battery, first check the battery connections. Then, charge the batteries overnight. If the error persists, replace the batteries or call for service, as the battery may be weak or bad.
What to do if my Minuteman Endeavor RTXL UPS is in battery mode even with AC?
If your Minuteman UPS operates in battery mode even when AC power is present, try resetting the input circuit breaker. If the breaker trips again after restarting the UPS, reduce the load on the UPS.
What to do if my Minuteman Endeavor RTXL doesn't provide expected runtime?
If your Minuteman UPS isn't providing the expected runtime, charge the batteries overnight and retest. If the runtime is still less than expected, the batteries may need to be replaced.
What does Minuteman Endeavor RTXL UPS error code E01 mean?
Minuteman UPS error code E01 indicates that the UPS has detected a short-circuit on its output. Check the attached load to resolve this issue.
Why my Minuteman UPS will not turn on?
If your Minuteman UPS will not turn on, press the On/Off/Test button and release it during the first beep.
What does Minuteman UPS error code E13 mean?
Minuteman UPS error code E13 indicates a fan failure or that the fan has stopped due to excessive dirt. If the fan has failed, call for service. If the fan is dirty, use a can of "Canned Air" to clean it.
What to do if my Minuteman Endeavor RTXL UPS AC normal icon is on, but there's no output?
If the AC normal icon is illuminated on your Minuteman UPS but there is no output, disconnect the computer cable from the UPS and press the On button. If the UPS works normally, the software has control of the UPS.
What does Minuteman Endeavor RTXL error code E33 mean?
Minuteman UPS error code E33 means you are trying to parallel two different UPS models. When paralleling UPSs, they must be the same model and VA ratings. Call for service.
What does Minuteman UPS error code E03 mean?
Minuteman UPS error code E03 indicates that the internal or ambient temperature has exceeded the temperature ratings. Check the specifications to ensure proper operating conditions.
What does Minuteman Endeavor RTXL UPS error code E04 mean?
Minuteman UPS error code E04 is an Input Over Current Protection Warning. To resolve this, check the specifications and remove part of the load.
To Next Page
General
