Miracle-Ear GO Remote - Page 11

11
X
Hold down the button until the pairing confirmation
sound is played in the hearing aids. It takes
approximately 2 seconds for the sound to start playing.
XEnsure that the confirmation sound is heard in both
hearing aids. When heard, the pairing will be complete.
The remote control will remain in setup mode for an
additional 30 seconds. The confirmation sound can
be played again by pressing
during these 30 seconds.
XTo exit the setup mode of the remote control,
wait 30 seconds or move the key lock switch to
the lock position (red color visible).
G43015_USRB_C GO Remote User Manual.indd 11 2/12/20 12:56 PM