Miracle-Ear GO Remote - Page 24

24
X
Release the button.
The remote control is now in setup mode, the LED
will be on and the signal strength can now be changed.
XTo switch to the lowest signal strength,
press
until the LED flashes slowly.
To switch to the strongest signal strength,
press
until the LED flashes quickly.
XTo exit the setup mode of the remote control,
wait 30 seconds or move the key lock switch
to lock position (red color visible).
XTo continue using your remote control,
ensure that it is unlocked (green color visible).
G43015_USRB_C GO Remote User Manual.indd 24 2/12/20 12:56 PM