Guide to Installation and Operation
Densité 2 Housing Frame
SAFETY COMPLIANCE
This equipment complies with:
CSA C22.2 No. 60950-1 Safety of Information Technology Equipment
UL 60950-1 Safety of Information Technology Equipment
IEC 60950-1 Safety of Information Technology Equipment
WARNING
An appropriately listed/certified mains supply power cord must be used for the connection of the equipment to
the mains voltage at either 120V~ or 240V~.
The power cord supplied with this equipment meets the appropriate national standards for the country of
destination.
CAUTION
These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock,
do not perform any servicing other than that contained in the operating instructions unless you are qualified to
do so. Refer all servicing to qualified service personnel.
ELECTROMAGNETIC COMPATIBILITY
This equipment has been tested for verification of compliance with FCC Part 15, Subpart B
requirements for Class A digital devices.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
This equipment has been tested and found to comply with the requirements of the EMC directive
2004/108/CE:
• EN 55022 Conducted emissions, Class A
• EN 55022 Radiated emissions, Class A
• EN 61000-3-2 Harmonic current emission limits
• EN 61000-3-3 Limitation of voltage changes, voltage fluctuations and flicker
• EN 61000-4-2 Electrostatic discharge immunity
• EN 61000-4-3 Radiated electromagnetic field immunity – radio frequencies
• EN 61000-4-4 Electrical fast transient immunity
• EN 61000-4-5 Surge immunity
• EN 61000-4-6 Conducted emissions immunity
• EN 61000-4-11 Voltage dips, short interruptions and voltage variations immunity
To Next Page
Loading...
Need help?
General
