Miranda Kaleido-X - Page 11

USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 7
OR to open a session with user privilege validation without MD5 password hash:
<openID>mirandagateway://USERNAME:CLEAR_PASSWORD
@SYSTEM_NAME/ROOM_NAME</openID>
Where:
o IP_ADDRESS is the IP address of your destination Kaleido frame.
o ROOM_NAME is the room context for the session (see getKCurrentLayout,
setKCurrentLayout and getKLayoutList).
o USERNAME is the username that will be used to validate permissions.
o PASSWORD_MD5_HASH is the md5 hash of the user password, encoded in base 64.
o For information on md5 see http://www.ietf.org/rfc/rfc1321.txt.
o For information on base 64 see RFC 3548.
o CLEAR_PASSWORD is the user password.
o SYSTEM_NAME is the system name as specified in XAdmin.
Gateway response:
 <ack/>: The command was recognized by the Gateway.
 <nack/>:
o The Gateway was not able to recognize the command OR
o The room name was invalid OR
o The username does not match the provided password OR
o The system name was invalid.
o The IP_ADDRESS parameter is wrong.
closeID KX K2 AQ
This command closes a session with the specified Kaleido.
On a Kaleido-X series multi-viewer:
<closeID/>
On a Kaleido-K2 or Kaleido-Alto/Quad/Quad-Dual multi-viewer:
<closeID>IP_ADDRESS_0_4_0_0</closeID>
Where IP_ADDRESS is the IP address of the Kaleido-K2 or Kaleido-Alto/Quad/Quad-Dual.
Gateway response:
 <ack/>: The command was recognized by the Gateway.