USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 21
<kAudioOut>Type="EMBEDDED" Input="AAA" Group="BB"
AES="X"</kAudioOut>
Where:
o AAA indicates the video input.
o BB indicates the group. Valid values are from 1 to 4.
o X indicates the AES. Valid value can be either 1 or 2.
<nack/>: The command was not executed.
setKAudioOut KX K2 AQ
The user can select the audio to be monitored by using this Gateway command. The syntax of
the command will differ if the user indicates to monitor audio coming from a stream, from an audio
card, from an embedded source or no audio at all. In general, you can select any audio source to
be monitored, even if this source is not represented in an audio meter on the current layout.
Notes:
A session with user privileges must first be opened for this command to work on a
Kaleido-X or Kaleido-X16 multi-viewer.
This command is currently not supported on the KMV-3901/3911 and Kaleido-IP models.
Streaming sources are not supported on the Kaleido-Alto/Quad/Quad-Dual.
<setKAudioOut>DETAILS</setKAudioOut>
Where DETAILS will differ depending on the type of audio source being selected for monitoring,
as shown below.
To select a streaming source, format the command as follows:
<setKAudioOut>set Type="STREAMING" IP="999.999.999.999"
FeedID="XX"</setKAudioOut>
Where:
o 999.999.999.999 is the IP of the machine from where the stream occurs.
o XX is the identifier of the feed to use.
To select an audio card source, format the command as follows:
<setKAudioOut>set Type="AUDIOCARD" Input="999"</setKAudioOut>
Where 999 indicates the input from the card.
To select an embedded source, format the command as follows:
<setKAudioOut>set Type="EMBEDDED" Input="AAA" Group="BB"
AES="X"</setKAudioOut>
Where:
o AAA indicates the video input.
To Next Page
Loading...
Need help?
General
