USER’S GUIDE
Kaleido Remote Control Protocol (Gateway) | 27
3 A Typical Session
Here is a description of how to open and close a typical session during which you will use these
commands to operate a Kaleido. You can open concurrent sessions with multiple Kaleido frames; each
session will have its own window on your desktop.
If you are using a Kaleido-K2, make sure the internal gateway is turned ON, and the MT-gateway
is turned OFF (see section 1.2).
If your environment includes a Miranda iControl Application Server, see the Application Server’s
manual for a discussion of appropriate network configurations.
Open the HyperTerminal software on another computer:
1. From the Start menu, point to All Programs > Accessories > Communications, and then click
HyperTerminal.
2. In Connection Description, type a name for the connection, and select an icon from the list.
3. In Connect To, select TCP/IP (Winsock) from the Connect using list.
Two new boxes appear in the window.
4. In Host address, type the IP address of the Kaleido frame.
5. In Port number, type “13000”. This indicates that the connection to the Kaleido will be established via
port 13000.
6. Click OK.
To Next Page
Loading...
Need help?
General
