What to do if my Mission M-Cube Subwoofer has no sound?
If there's no sound coming from your Mission Subwoofer, check the following: Ensure all connections are secure, verify that your AV receiver is set to the correct input channel, confirm the volume is above zero, check that the subwoofer's power status indicator is on, and make sure the audio source is properly connected and powered on.
How to fix low sound output on a Mission Subwoofer?
To address low sound output from your Mission Subwoofer, check the polarity of the speaker level connectors at the receiver and verify the fine volume level on the subwoofer.
Guidelines for reading, keeping, following, and general safe usage of the apparatus.
Precautions for installation near heat sources, ventilation, and power cord protection.
Precautions concerning electrical storms, servicing, fire risk, and mains plug.
Advice on fitting spikes, positioning equipment, and optimal subwoofer placement.
Instructions for connections, amplifier usage, system startup, and tone control settings.
Notes on environmental conditions, packaging, and avoiding disassembly.
Welcome message and introduction to the M-Cube subwoofer's capabilities.
Details on warranty terms, exclusions, and claim procedures.
Guidance on carefully unpacking the subwoofer and retaining packaging materials.
Step-by-step guide for connecting the receiver's speaker outputs to the subwoofer.
Important information regarding connecting all receiver channels and rear centre channels.
Instructions for powering the subwoofer on and off using the mains switch.
Explanation of the subwoofer's factory default settings and controls.
Guidance on adjusting Fine Volume, Crossover, Bass Contour, and Phase controls.
Details on the Auto Power ON and Auto Power OFF functions for standby modes.
Instructions for fitting rubber feet for hard floors and spikes for carpeted floors.
Explanation of the overdrive protection circuitry and how to manage activation.
Procedure for returning the product for service or contacting Mission support.
Solutions for common issues like no sound, low output, and distorted bass.
Instructions for cleaning the subwoofer using soft, dry cloths only.
Detailed technical data including drive units, enclosure, power, frequency response, and dimensions.
Information on the types of RCA and speaker level inputs and outputs available.
To Next Page
General
