Mistral MSF1679R - Remote Control Usage and Safety; Fan Adjustments and Power

6
Warning
•
•
•
How to use the remote control
•
•
•
Overheat motor protection
•
Control Panel
•
Tilt adjustment
•
Height adjustment
•
Power o/ memory
•
Do not dispose of batteries in re, batteries may explode or leak.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Point the remote controller at the receptor on body of the fan and press the desired button.
The remote controller will work at distances of up to roughly ve meters and the angle of
30 degree included between right and left from the receptor.
The batteries must be removed from the remote controller before it is scrapped and that
they are disposed of safely.
The windings of the motor have a thermal-fuse that burns out and the fan switches o and
temperature of the motor is no longer going up so that plastic parts of the fan don’t subject
to deformation so far so to be burned by the overheat if the motor is overheat for any
unexpected reason.
These keys of the control panel may be used as same as of the remote controller.
To adjust the air ow upward or downward, push the grilles lightly to the desired direction.
The height of the fan can be adjusted by loosening the height adjustment ring carefully
raising or lowering the fan and rmly re-tightening the height adjustment ring.
Fan shutdown or power o, the power is switched on again starts, will be operating in the
state of shutdown or power o (not before the timing function of memory).