10
If you select a network that is secured with WEP, enter the key and then tap
CONNECT.
5. When your device is connected to a wireless network, the WIFI icon (
) will
appear in the status bar indicating the signal strength (number of bands that
light up).
Bluetooth connection
To pair a Bluetooth device for sharing data:
1. Tap
on the desktop
Settings
Bluetooth.
2. Tap the Bluetooth switch to turn it on. The device will automatically scan for
available Bluetooth devices.
Note: By default, your device is not in visible mode when Bluetooth is turned on. If you need to enter visible mode: tap
Bluetooth and then tap your device name. The default visibility timeout is 2 minutes.
3. Tap a device from the list to initiate pairing.
4. On your device, the passkey is displayed. Make sure the same passkey is
displayed on the other device and then tap PAIR. Then tap PAIR on your
device to conrm pairing if necessary.
Caring for your device
Troubleshooting
Note: If you encounter a problem you cannot solve, contact an authorised service centre for assistance.
Power does not switch on when using battery power.
The remaining battery power may be too low to run your device. Charge the
battery.
Screen responds slowly.
Make sure that your device is not running out of battery power. If the problem still
persists, restart your device.
To Next Page
Loading...
