MITACA pod 1 plus - Programming Dispenser Buttons; Brewing Coffee with Pods

10
Programming the dispenser buttons
Large cup: press and hold the button (D). The machine
will dispense water. When the desired water quantity has
been reached, release the button
(D). The machine will
stop delivering water and will store the quantity of water to
be dispensed from now on. (Fig.8)
Small cup: Use the same procedure as for large cups. Press
and hold the corresponding button (E).
The machine will start dispensing water. When the desired
level of water is reached, release button
(E). The machine
will stop delivering water and will store the quantity of water
to be dispensed from now on. (Fig.8)
• Use pods suitable for this model only.
• Place a cup under the dispenser
• Lift the control lever backwards (up to the stop point) (1)
and make sure that the pods ejection hatch (15) is open.
(Fig.9)
ATTENTION: if the hatch (15) is closed,
open it manually (Fig. 10)
• Introduce the pad properly into its seat as shown on the figure
(Fig. 11)
• Fully lower the lever (1) and press either the large cup
(D) or small cup (E) dispenser button depending on personal
taste.
(Fig. 12)
• To fully remove the pod, slowly lift the lever (1).
If the pod is not ejected, open the hatch (15) and remove it.
Preparation of coffee
1
Fig. 12 Fig. 11
Dispenser buttons:
9
Fig. 9
15
1
Fig. 10
15
UP
D
E
Fig. 8
D
E