3. Align the round hole in the platter with the pulley and use your finger to hook the belt onto
the pulley.
4. Place the turntable mat on the platter.
Install dust cover
1. Insert the dust cover hinges into the hinge bases on the back panel of the unit.
2. Hold the dust cover and insert it into the hinges.
Note: When you want to take out the platter from the turntable, remove the mat first, then
grasp the platter and pull it upward. This is especially important if you are shipping your
turntable to prevent the platter from shaking.
Note: To remove the dust cover, grasp the two sides of the dust cover and
slowly lift upward to remove the dust cover together with hinges.
To Next Page
Loading...