Mitchell uStreamTT1 - Playing a Record

Using your turntable
Plug one end of the power cord into the AC power jack on the back of the turntable, and then
plug the other end into a power outlet.
Playing a record
1. Gently open the dust cover.
2. Place a vinyl record on the turntable.
3. Select the appropriate speed by turning the RPM selector switch to 33 or 45.
4. Remove the tone arm-rest lock catch to release the tone arm.
5. Push the tone arm lifter forward to raise the tone arm.
6. Gently push the tone arm to the left over the turntable.
7. Push the tone arm lifter backward to lower the tone arm so that the stylus touches the
record and starts to play.
8. To pause or stop playing, push the tone arm lifter forward to raise the tone arm.
9. When playing is completed, push the tone arm lifter forward to raise the tone arm, and
then move the arm back to the tone arm rest. Push the tone arm lifter down to lower the
tone arm.
Listening to music using Mitchell Acoustics uStream Bluetooth speakers
Note:
1. We strongly recommended that you operate your turntable only from the type of
power source indicated on the marking label.
2. To prevent interference, avoid bundling the audio signal cables together with the AC
power cord.
3. The top cover helps prevent dust from settling on your turntable. We recommend that
you use the top cover when you’re playing records or when you’re not using your
turntable.
Note: Be careful not to pinch your finger when opening or closing the dust cover.
Note: When playing a 45 RPM record, use the included 45 RPM adapter.
Note: When the end of the record is reached, the tone arm and rotation stop.
Notes:
1. Closing the top cover helps prevent dust from settling on the turntable.
2. Always relock the tone arm clip before transporting your turntable.
3. Do not place anything on top of the turntable cover, especially while playing a record.