Mitel Superset 4090 Documentation

SECTION MITL91 OS/91 lo-096~500-NA
.
card slot, dial 555 + 5 + nn from the test line or the console, where nn :
is the card slot number (l-i7 shelf 1, 31-42 shelf 2). Since inserting a
card may cause diagnostic errors, this procedure is normally followed
by dialing 555 + 1 to clear ail system errors.
G. System Reset
5.11 The test line or console may reset the system by dialing 555 +
6.
.
H. Customer Data Dump/Load
5.12 The customer data dump/load feature allows the programmer
to dump all the cuzzomer data to a recording device and/or
load all or specific blocks G: customer data. Refer to Table 5-l for the
type of data that each block contains.
I
Hardware
Position Number
I-
091 099 107 115
I I I
092 100 108 116 ---- --
093 101 109 117
094 102 110 118 --
095 103 111 119
096 104 112 120 ---
12 13 14 15 Card Position i . f :
Figure 5-1 Receiver Equipment Numbers

Mitel Superset 4090 Specifications

General

Brand	Mitel
Model	Superset 4090
Category	Controller
Language	English