22
Using and Canceling the Work Timer
The Work Timer provides a delay after each ACD call, before the next call is
directed to you. This gives you a certain amount of time to compete any work
generated by the previous call.
The Work Timer is automatic and you are not required to perform any procedures
to activate it. The length of time provided by the timer varies from 0 to 600
seconds, and is programmed only by the System Administrator.
Work Timers apply to ACD Agents and ACD calls only. Other calls to and from
your set do not activate a Work Timer. If the Make Busy or Do Not Disturb
features are activated at your telephone, the Timer is cancelled for that call.
Once you terminate an ACD call, WORK TIMER appears on the display for the
duration of the Work Timer period, as shown below:
When the Work Timer expires, WORK TIMER disappears from the display and
you are ready to take another call.
You have the option of canceling the Work Timer and accepting another call
before the Timer expires. Cancellation of the Timer affects only the next ACD
call.
To cancel the Work Timer, press the Cancel Function Key. Your set displays the
normal screen and is now available for the next ACD call.
To Next Page
Loading...
