100% 90% 80% 70% 60% 50% 40% 30% 20%
Battery level indicators
(During self-test)
EMF MeterManual (A6) V1.indd 6 2/14/18 1:41 PM
Operation
The Mito Meter is a 3-mode detector, these modes are:
• RF - Radio Frequency
• LFM - Low Frequency Magnetic
• LFE - Low Frequency Electric
It is recommended to fully charge the device before using it
for the rst time. To do so, use the supplied mini-USB cable
to connect to a USB charger or computer. During charging,
the LED will show RED – when fully charged the LED will be
o. A full charge should give 8-10 hours of operation.
Note: On activation the meter will perform a quick (3
second) self-test before full operation. This includes:
• Cycling through the LEDs from left to right, accompanied
by a tone. (If the sound is turned ON).
• The device will then check the battery status and show
the charge:
To Next Page
Loading...