Mitox 260LX - Page 14

260LX/UX, 330LX/UX, 430UX, 530 UX
Brushcutter
14
Original Instructions Version August 13
Installing the Nylon Head
• LaytheBrushcutteronitsbackwiththegearboxshaftfacingup.
Rotate the gear box shaft until the hole
in the holder A lines up with the hole in
the metal guard.
Insert an Allen key or screwdriver into
the hole in the metal guard and into
holder A.
Screw the nylon head anti-clockwise
(turn left) onto the threaded shaft on the
end of the gearbox.
Make sure that the nylon head is se-
curely locked in position and remove the
Allen key.
A
A