Mitox 360UX - Page 15

360UX, 460UVX Premium Brushcutter
15
Original Instructions Version November 17
360UX/460UVX_1011171
Installing the Nylon Head
Lay the Brushcutter on its back with the gearbox shaft facing up.
Rotate the gear box shaft until the hole
in the holder (a) lines up with the slot in
the metal guard (b).
Insert an llen key or screwdriver into
the hole in the gearbox cover and into
holder (a).
Screw the nylon head anti-clockwise
(turn left) onto the threaded shaft on the
end of the gearbox.
Make sure that the nylon head is securely
locked in position and remove the llen key.


B