Mitox 360UX - Component Location; Warnings in the Manual

360UX, 460UVX Premium Brushcutter
3
Original Instructions Version November 17
360UX/460UVX_1011171
Warnings in the Manual
This mark indicates instructions which must be followed in order to prevent accidents which could
lead to serious bodily injury or death.
This mark indicates instructions which must be followed or it leads to mechanical failure,
breakdown, or damage.
This mark indicates hints or useful directions in the use of the product.
IMPORTANT
!
NOTE
Component Location
1 NYLON CUTTING HED uto bump feed nylon cutting head.
2 DRIVE SHFT Contains the drive shaft.
3 THROTTLE TRIGGER Spring loaded to return to idle when released.
4 IGNITION SWITCH Slide switch, forward to run, back to stop.
5 SFETY LEVER Prevents accidental operation of the throttle.
6 HNDLE This handle can be adjusted for maximum comfort
7 HRNESS SSEMBLY Fully adjustable for maximum comfort
8 PETROL CP
9 PURGE BULB Push the purge bulb to remove the air from the fuel system.
10 FUEL TNK Contains fuel and fuel filter
11 IR CLENER Contains replaceable filter
12 CHOKE To help in cold starting
13 STRTER HNDLE Pull to start the engine
14 DEBRIS SHIELD Helps protect the operator from debris
15 CUT-OFF KNIFE Cuts the nylon line to the correct length
16 FRONT HNDLE This handle can be adjusted for maximum comfort
17 GERBOX For attaching a blade or nylon head to
18 RER HNDLE Incorporating throttle trigger, switch, and safety lever
19 HRNESS FIXING POINT Fixing point to attach the harness
20 METAL BLADE Metal blade cutting head