Mitox CS450X - Guide Bar; Other Checks

CS450X / CS500X / CS560X PREMIUM
21
Original Instructions Version July 16
CS450X-CS500X-CS560X_190716
Maintenance After Each Use
Oiling port
Dismount the guide bar and check the oiling port (1) for clogging.
Guide bar
When the guide bar is dismounted, remove sawdust from the bar groove and the oiling port.
Grease the nose sprocket with a sprocket grease gun (Oregon part number 21939)
1. Guide bar groove
2. Oil hole
3. Drive sprocket
4. Grease point
Other Checks
Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints
and guide bar mounting. If any defects are found, make sure to have them repaired before
operating the saw again. Check for cracks and for excessive wear interfering with the chain drive.
If the wear is considerable, replace it with a new one. Never fit a new chain on a worn sprocket,
or a worn chain on a new sprocket.