Mitsubishi Electric a2 Series - Programming Methods; Direct Programming; AL-PCS;WIN-E Programming Software Ver 2.00 and Upwards

α 2 Simple Application Controllers
Function Block Programming 2
2 - 5
2.2 Programming Methods
2.2.1 Direct Programming
Direct Programming uses the keys on the front panel to create the program and enter any
required data values. The method for Direct Programming is explained in Chapter 4 of this
manual.
2.2.2 AL-PCS/WIN-E Programming Software Ver 2.00 and upwards
This windows based software allows the user to drag and drop the desired Function Block
icons onto the FBD base and construct a program. The program is downloaded to the
α
2
controller via the AL-232CAB cable. The visual on-screen connections make the software easy
to grasp for beginners and experienced users alike. The AL-PCS/WIN-E Programming
Software is fully explained in the
α
Software Manual (JY992D74001).
Figure 2.1: AL-PCS/WIN-E Programming Software Ver 2.00 and upwards
Note: Do not simultaneously program the
α
2 Series Controller from the direct
programming keys and AL-PCS/WIN-E Ver 2.00 methods as this may result in
unexpected operation and possibly cause harm.