Mitsubishi Electric a2 Series - Page 58

α 2 Simple Application Controllers
Function Blocks 6
6 - 4
Multiplicati
on
[MUL]
The MUL Function Block is used to multiply
two input values.
20 Byte 6.26
Division
[DIV]
The DIV Function Block is used to divide
two input values.
20 Byte 6.27
Calculatio
n
[CAL]
The CAL Function Block is used to perform
a calculation from the combination of
different Arithmetic function blocks.
*3 6.28
Shift
[SFT]
This Shift Function Block is used to transfer
the Shift Input status just before the Input
signal is set ON. It has a bit input pin, a shift
input pin, a set input pin, a reset input pin
and a bit output pin.
19 Byte 6.29
SMS
[SMS]
The GSM SMS Function Block sends the
LCD screen as a SMS message to either a
mobile phone handset or an E-mail account
for remote maintenance purposes.
*6 6.30
Random
One Shot
[ROS]
The Random One Shot Function Block
emits a random length single pulse to the
output.
19 Byte 6.31
Delayed
One Shot
[DOS]
The Delayed One Shot Function Block
emits a single pulse after a controlled delay
to the output.
20 Byte 6.32
Delayed
Alternate
[DAL]
The Delayed Alternate Function Block
alternates the status of the output with each
pulse after a controlled delay.
16 Byte 6.33
FB Name FB Symbol Description of Function Block
Memory
Use
Section
000
UM
OI
L
P
000
ID
OI
V
P
000
AC
OI
L
P
000I
TS
OT
S
R
F
P
000
MS
OI
S
P
000
OR
OI
S
C
P
000
OD
OI
S
C
P
000
AD
OI
L
C
P