Mitsubishi Electric a2 Series - Page 99

α 2 Simple Application Controllers
Function Blocks 6
6 - 45
Setup of the Hour Meter Function Block directly from the
α
2 Series Controller
1 ) Allocate the input pin to be used for the function block.
2 ) Press the “OK” key with the cursor in the function block. The function block edit screen is
displayed as shown.
3 ) Press the “OK” key to set the Time unit for the delayed output.
4 ) Press the “OK” key having selected the correct time unit and return to the function block
edit screen. Using the “ and ” keys highlight the Setup FB and press the “OK” key.
5 ) Press the “OK” key with Hour highlighted and using the “ , , + and -” Keys enter the total
hour time for the specified block.
6 ) Press the “OK” key with Minute highlighted and using the “ , , + and -” Keys enter the
total minute time for the specified block.
Time
Se t up FB
B001 :HM
un i t
Change No
De l e t e FB
hh :mm
Time uni
mm : s s
t
Hou r
B001 :HM
Mi nut e
Hou r
B001 :HM
T= 1h
t= 0h
Mi nu
B001 :HM
T= 0m
t= 0m
te