Chapter 7. Using IEEE 1394 Devices 85
A/V Discs
A/V Disc Track List Screen
When viewing an A/V Disc:
• Press GUIDEto display itsTrack List (see figure below).
• Press A or V to navigate through the Track List.
• To play a track, select it on the list, then press ENTER.
= Press INFOto view details for a highlighted track.
To move through listings quickly, press PAGE/k/V.
To delete a track, highlight it and press CANCEL.
Figure 4. A/V Disc Track List screen
A/V Disc Search by Time
While playing an IEEE 1394 A/V disc you can search to a
specific time in the recording.
1. Start playing the desired track on the A/V disc.
2. Use the number buttons to enter the time code posi-
tion of hours followed by minutes. For example, to
enter one hour and twenty-two minutes (1:22) into the
track, enter 1, 2,2.
3. Press ENTERto skip to the time code position. To
cancel the request or to start over, press CANCEL
instead of ENTER.
Copying A/V Disc Recordings
Tracks you record to disc may have copy restrictions
assigned to them. To learn a track's copy status, high-
light the track in the Track List and press INFO.Tracks are
assigned one of these ratings:
(or no status shown)
Copy Never The track cannot be transferred to
another recording device. Tracks
of this type may have an assigned
retention period. See below for
more information.
il i
Retention Period
Some COPY NEVER tracks have a retention period
assigned by the content provider. The retention period
is the length of time you can keep and view the record-
ing. The initial retention period, if any, is shown next to
the copy status in the Track List INFOdisplay (see figure 4).
To check how much time remains of the retention period,
start viewing the recording and press INFO.
Note: The retention period for all tracks on the disc
expires if there is any loss of power to the TV, even
momentary. For example, expiration of the reten-
tion period will occur if you:
Unplug the TV from the AC power source.
Experience a power outage or power
fluctuation.
Remember that you can safely turn off TV power
using the POWERbutton without affecting the reten-
tion period.
To Copy a Track to Another IEEE 1394 Device
1. Press INPUTon the remote control and press A Y 4 I_
to select the source A/V disc. Press ENTERto open the
Track List.
2. Press A or Y to select a track. Then press ENTERto
start playback.
3. Press (_ (PAUSE}to pause playback.
4. Press (_ (RECORD}on the TV remote. The Record
menu will display.
5. In the Record To section, review the destination
device (A/V Disc, DVCR). Change if necessary. If
moving, leave the other settings unchanged.
6. Press _ a second time to start recording.
To Next Page
Loading...
Need help?
General
