6. HF-KN SERIES
6 - 7
(2) Tighten the screws evenly. Tightening torques are as indicated below.
Connector for electromagnetic brake
Screw size: M2
Tightening torque: 0.2 N•m
Connector for power supply
Screw size: M2
Tightening torque: 0.2 N•m
Connector for encode
Screw size: M2
Tightening torque: 0.1 N•m
(3) The servo motor fitting part of each connector is provided with a splash-proof seal (O ring). When
mounting a connector, use care to prevent the seal (O ring) from dropping and being pinched. If the seal
(O ring) has dropped or is pinched, a splash-proof effect is not produced.
To Next Page
Loading...
