Mitsubishi Electric MELSERVO-J5 - Page 386

384
4 APPLICABLE FUNCTIONS
4.24 Override function [G]
■Point table mode (Set of set-points)
The following shows a timing chart when bit 9 (Change on set-point) of [Controlword (Obj. 6040h)] is "0".
Controlword bit 4
(New set-point)
Target point table
Speed override
[Obj. 2DB0h]
1
150 %
50 % 200 %
ON
OFF
ON
OFF
Statusword bit 12
(Set-point acknowledge)
ON
OFF
ON
OFF
Statusword bit 10
(Target reached)
Control DI 7 bit 7
0 r/min
Forward
rotation
Servo motor speed
Reverse
rotation
(C_OVR (Override selection))
Override 100 %
Override 150 %
Override 50 %
Override 100 %
Speed of New set-point (1st time)
Speed of New set-point
(2nd time)
Time constant of New set-point (1st time)
Time constant of New set-point
(2nd time)
New set-point (1st time) New set-point (2nd time)
Override 200 %