What causes error H0242 in Mitsubishi Electric Industrial Electrical?
If your Mitsubishi Electric Industrial Electrical system detects a fault in safety data (error H0242), turn the power OFF and then ON again.
Why does Mitsubishi Electric Industrial Electrical show error H0249?
If multiple networks have been selected for the safety communication function in your Mitsubishi Electric Industrial Electrical (error H0249), check and correct the network selection settings of the safety parameter.
What to do if Mitsubishi Electric Industrial Electrical safety function is disabled (C0240)?
If the safety function is disabled in your Mitsubishi Electric Industrial Electrical (error C0240), even though the safety logic is configured, you should either delete the safety logic or enable the safety functions.
What to do if Mitsubishi Electric Industrial Electrical safety IO is disabled (C0244)?
If the safety IO logic is set but the safety IO is disabled in your Mitsubishi Electric Industrial Electrical (error C0244), you should either delete the safety IO logic settings or enable safety IO.
What to do if Mitsubishi Electric Industrial Electrical safety communication is disabled (C0245)?
If the safety communication logic is set, but the safety communication function is disabled in your Mitsubishi Electric Industrial Electrical (error C0245), you should either delete the safety communication logic settings or enable safety communication.
General| Number of Axes | 6 |
|---|---|
| Degrees of Freedom | 6 |
| Applications | Assembly, Material Handling |
| Controller | CR800 |
| Repeatability | ±0.02 mm |
| Installation | Floor, Wall, Ceiling |
| Protection Class | IP67 |
| Series | RV-FR Series |
| Weight | Varies by model |
To Next Page