PC Viewing
Figure I
To dispHay your PC screen on the TV, first connect
the PC to the HDMI 2 input on the TV's back paneH
(see Chapter 2). You must then activate the PC
option in NetCommand. You can do this during initiaH
NetCommand setup by seHecting the PC option in the
Device Setup screen. To do this at any time afterwards,
use the NetCommand Add function. You will then be
aMe to seHect the PC through the Device SeHection Menu.
For the correct screen resoHufion (pixeHs),use the PC's
ControH PaneHsettings as described bellow.
Your Mitsubishi TV can dispHay resoHufions from standard
VGA (640 x 480) through XGA (1024 x 768) 60-Hz refresh
rates onHy. See Appendix A in this book for more on
screen resoHutions. The instructions bellow are for most
PCs.
1. In the PC's Start menu, select Settings.
2. Select Control Panel.
3. Select Display.
4. Choose the Settings tab.
5.
Depending on your PC, adjust the resolution with
either:
the Screen area slider.
the Screen Resolution slider
You may need to restart the PC for this change to take
effect.
Hint: Whenever the TV is powered on, the lamp is
in use, even if the TV screen appears dark. As a
reminder that the TV is powered on and that time
is being added to the lamp's elapsed hours, set the
computer's screen saver to a pattern that will display
after several minutes of inactivity.
2_
Figure I. PC resolution XGA selection
3_
Chapter 6. Additional Features 89
To Next Page
Loading...
Need help?
General
