NOTE
l
The brightness level of the instruments is
stored when the operation mode of the pow-
er switch is put in OFF.
l
If you press and hold the button for about 2
seconds or more when the position lamps are
illuminated, the brightness level changes to
the maximum level. Pressing and holding
the button for about 2 seconds or more again
returns the brightness level to the previous
level.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS), the
map screen colour of MITSUBISHI Multi-
Communication System (MMCS) may not
be switched to nighttime setting when the
meter illumination brightness level is at the
maximum.
Multi information display
E00519902526
Always stop the vehicle in a safe place before
operating.
The following information is included on the
multi information display: warnings, odome-
ter, tripmeter, average fuel consumption, EV
cruising range, total cruising range, EVHV
driving rate, energy flow, etc.
[When the operation mode of the power
switch is OFF]
1-
mark display screen ® p. 6-10
2- Information screen ® p. 6-06
Interrupt display screen ® p. 6-09
3- Drive battery level display screen
® p. 6-10
4- Odometer ® p. 6-11
5- “
” or “ ” “mark indicator” on page
6-09
6- Door ajar warning display screen
® p. 6-10
NOTE
l
The drive battery level display screen ap-
pears when any of the doors or the tailgate is
opened during charging.
[When the operation mode of the power
switch is ON]
Multi information display
6-03
OGGE16E1
Instruments and controls
6
To Next Page
Loading...
Need help?
General
