5-23
• On icy, snow-covered, or otherwise slippery
roads
• Steep downhill road
The vehicle speed may become higher than the set
speed on a steep downhill road. Stop using the
cruise control if this occurs.
Main switch
This switch is used to activate and deactivate
the cruise control function. The lamp inside the
switch illuminates when the cruise control is on.
The switch returns automatically to the neutral
position after having been pressed.
SET/RESUME switch
SET:
Press this side of the switch to set a desired
speed and to reduce the set speed as well. The
switch returns automatically to the neutral posi-
tion after having been pressed.
RESUME:
Press this side of the switch to change the set
speed to a higher speed and to return to the pre-
viously set speed as well. The switch returns
automatically to the neutral position after having
been pressed.
Cruise control indicator lamp
If the cruise control is activated, this lamp illumi-
nates during driving.
NOTE:
The indicator lamp will light up when the starter
switch is turned to the ON position and the engine is
not running. It will go out in a few seconds if there
are no problems.
1 To set a desired speed
1. Check that the exhaust brake switch is in the
OFF position. If the switch is in the ON position,
place it in the OFF position.
Press the ON side of the cruise control main
switch. The lamp inside the switch will illumi-
nate.
WARNING
For safety, turn off the main switch when the
cruise control is not in use.
Z18568
Z18569
FE_FG.book Page 23 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
