5-24 Switches and controls
2. Depress the accelerator pedal until the desired
speed is reached.
3. When the desired speed is reached, press the
SET side of the SET/RESUME switch. The
indicator lamp will illuminate indicating that the
cruise control is activated. Now the desired
speed is memorized, so release the accelerator
pedal. The vehicle will run maintaining that
speed automatically.
NOTE:
• The selector lever must be in the “D” position
when setting the desired speed.
• Before pressing the ON side of the main switch
to set a desired speed, make sure the exhaust
brake switch is in the OFF position. You will not
be able to set the speed if the exhaust brake
switch is in the ON position. When driving with
the cruise control active, exhaust braking can be
used as usual, but the cruise control function will
be deactivated while exhaust braking is being
used.
2 To increase the set speed in cruise con-
trol mode
•
By using the SET/RESUME switch
Continue to press the “RESUME” side of the SET/
RESUME switch. The vehicle will accelerate.
Release the switch when the desired speed is
reached. The vehicle will cruise at the new, higher
speed.
Z11829
Z18570
Z16860
FE_FG.book Page 24 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
