Mitsubishi A1SD75P2-S3 - Page 213

5 - 116
MELSEC-A
5 DATA USED FOR POSITIONING CONTROL
Setting item Setting details
•
Set the JOG speed for JOG operation.
•
The value is set within the following range.
Pr.1
Pr.11
mm
(
×
10
-2
mm/min)
inch
(
×
10
-3
inch/min)
degree
(
×
10
-3
degree/min)
pulse
(pulse/s)
Standard
mode
0 to
600000000
0 to
600000000
0 to
600000000
0 to 1000000
Stepping
motor mode
0 to 37500000 0 to 37500000 0 to 37500000 0 to 62500
Cd.19
JOG speed
Cd.20
Speed/position changeover
enable flag
•
Set whether to validate the control signal (speed/position changeover signal)
from an external source.
•
To change the movement amount for the position control during speed control of
speed/position changeover control, set the movement amount after changing to
position control.
•
Make the setting during the speed control of speed/positioning changeover
control.
•
The setting value is cleared to 0 at the next start.
•
Set the value within the following range.
Pr.1
Pr.11
mm
(
×
10
-1
µ
mm)
inch
(
×
10
-5
inch)
degree
(
×
10
-5
degree)
pulse
(pulse)
Standard
mode
0 to
2147483647
0 to
2147483647
0 to
2147483647
0 to
2147483647
Stepping
motor mode
0 to
134217727
0 to
134217727
0 to
134217727
0 to
134217727
Cd.21
Speed/position changeover
control movement amount
change register
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com