SECTION 1
SECTION 1
PRODUCT SPECIFICATIONS AND HANDLING
SECTION 1 is configured for the following purposes (1) to (5).
(1) To understand the outline of positioning control, and the AD75 specifications
and functions
(2) To carry out actual work such as installation and wiring
(3) To set parameters and data required for positioning control
(4) To create a sequence program required for positioning control
(5) To understand the memory configuration and data transmission process
Read "SECTION 2" for details on each control.
Chapter 1 PRODUCT OUTLINE ...................................................................................1-1 to 1-20
Chapter 2 SYSTEM CONFIGURATION .......................................................................2-1 to 2-10
Chapter 3 SPECIFICATIONS AND FUNCTIONS ........................................................3-1 to 3-18
Chapter 4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT .....4-1 to 4-20
Chapter 5 DATA USED FOR POSITIONING CONTROL......................................... 5-1 to 5-186
Chapter 6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL.............6-1 to 6-38
Chapter 7 MEMORY CONFIGURATION AND DATA PROCESS...............................7-1 to 7-18
To Next Page
Loading...
Need help?
General
