Need help?Do you have a question about the Mitsubishi M80 series and is the answer not in the manual?
General| Type | CNC Control Unit |
|---|---|
| Power Supply | 24V DC |
| Interpolation | Linear, circular, helical |
| Fieldbus | CC-Link |
| Operating Temperature | 0 to 45°C |
| Interface | USB, RS-232 |
| Processor | RISC processor |
| Ethernet | Yes (100BASE-TX/10BASE-T) |
Details essential safety measures to prevent electric shocks during operation and maintenance.
Outlines precautions to prevent fires, including proper installation and handling of electrical components.
Covers safety measures to prevent injuries during handling and operation, including warnings about moving parts and heat.
Covers essential guidelines for wiring, including connecting and disconnecting cables safely.
Explains how to connect the emergency stop switch to the control unit's EMG connector.
Guides on writing data for the setup installer into an SD card and activating it.
Details the necessary parameter settings for system specifications.
Explains how to set parameters related to machine specifications.
Describes saving and writing sequence programs to the NC using an SD card.
Guides on writing sequence programs to the CNC's temporary storage using GX Works2.
Details the procedure for writing sequence programs to ROM using GX Works2.
Covers how to check input/output signals and alarm displays on the NC.
Guides on adjusting the absolute position zero point initialization using various methods.
Covers compensation methods for pitch errors and relative position errors.
Explains how to compensate for bidirectional pitch errors in linear and rotary axes.
To Next Page