Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
19 Setting the Parameters and Date/Time
424
IB-1501269-J
19.4 Setting Date and Time
(1) Select [Time] on the Monitr screen.
(2) Select [Time setting] on the integrated time screen.
The time setting mode is entered. The cursor appears at the "#1 Date" position in the Run-out time display.
(3) Set the date and time to "#1 Date" and "#2 Time" respectively.
(4) Select [Selfdia] on the diagn screen.
(5) Select [Battery clear] on the self diagn screen, and set the battery used years to "0".
(Note) If battery used years is not cleared, passed years from default date (2014/4/1) will be displayed on battery
used years.

Mitsubishi M80 series Specifications

General

Type	CNC Control Unit
Power Supply	24V DC
Interpolation	Linear, circular, helical
Fieldbus	CC-Link
Operating Temperature	0 to 45°C
Interface	USB, RS-232
Processor	RISC processor
Ethernet	Yes (100BASE-TX/10BASE-T)