M800S/M80/E80 Series Connection and Setup Manual
18 Setting Up with M80/M800S SETUP INSTALLER
418
IB-1501269-J
18.5 Install User Cycle
Carry out the procedures of this section to register user cycle. When you do not use user cycle, there is no need to carry
out the procedure.
(1) Push the [Custom Cycle] menu.
-> The screen is changed to user cycle installation screen.
(2) Push the [Install] menu.
(3) When a confirmation screen appears, push the [Yes] menu.
(Note) Do not power OFF during installation.
(4) When installation is finished, "Installation completed" appears.
(Note 1) To uninstall the user cycle, push the [Install] menu instead of [Uninst] in the step (2).
(Note 2) The size of user cycle must be 30MB or less. If it exceeds 30MB, the following message appears and the
installation fails.
"Installation Error. Please check the file size."
(Note 3) Installation or uninstallation is not executed when the [Yes] menu is pressed continuously after the previous
installation or uninstallation operation. Push Return key to return to the initial screen and start the
procedure again.
,QVWDOOLQJ
To Next Page
Loading...
Need help?
General
