Mitsubishi M80 series User Manual

M800S/M80/E80 Series Connection and Setup Manual
16 Setup Outline
379
IB-1501269-J
For other settings, refer to the following chapters:
- Setting the Deceleration Check
- Adjust S-analog Screen
- Device Open Parameter Screen
- SRAM Open Parameter Screen
- Data Backup and Restoration
When using the system lock, refer to the chapter of "Appendix 1: Setting the System Lock".
When using the protection setting, refer to the chapter of "Appendix 2: Protection Setting".

Mitsubishi M80 series Specifications

General

Type	CNC Control Unit
Power Supply	24V DC
Interpolation	Linear, circular, helical
Fieldbus	CC-Link
Operating Temperature	0 to 45°C
Interface	USB, RS-232
Processor	RISC processor
Ethernet	Yes (100BASE-TX/10BASE-T)