M800S/M80/E80 Series Connection and Setup Manual
18 Setting Up with M80/M800S SETUP INSTALLER
412
IB-1501269-J
(Note) M80/M800S SETUP INSTALLER is used to install language data other than Japanese and English, as well as
custom screens.
If you do not need the installation, go to the next section.
You can install the following data with M80/M800S SETUP INSTALLER.
(1) Custom data
- Custom screen
- PLC alarm guidance
(2) Custom startup screen
(3) APLCdata
An SD card is used for the installation.
MITUBISHI will not provide performance guarantee and maintenance for commercially available SD card. In the case of
using a commercially available SD card, careful performance check must be required by the machine tool builder.
Commercially available devices may not be compatible with MITSUBISHI units or suitable FA environment for
temperature or noise-wise.
To Next Page
Loading...
Need help?
General
